mirror of
https://github.com/gesellix/Bose-SoundTouch.git
synced 2026-08-18 08:36:13 +00:00
Tobias GesellchenandClaude Opus 4.7
29a462da2b
Add `soundtouch-cli setup` subcommand group covering the full reset →
re-provision → pair lifecycle as a scriptable alternative to the web UI:
inspect, verify, plan, factory-reset, wait-ap, wifi-push, wait-online,
ssh-check, install-ca, migrate, reboot, pair (bare | full state machine)
Supporting library code lives in pkg/service/setup: factory_reset.go,
wifi_provision.go, inspect.go, init_plan.go, setup_session.go.
Confirmed against ST10 firmware 27.0.6 that bare setMargeAccount over
WebSocket — no SETUP_START/SETUP_ENTER/SETUP_LEAVE bracket — is
sufficient to pair a factory-reset speaker; the firmware materializes
SystemConfigurationDB.xml and Sources.xml itself and the pairing
survives reboot. Result and field-by-field SystemConfigurationDB
comparison documented in docs/analysis/SETUP-WEBSOCKET-EXPERIMENT.md.
Captures the device's pre-reset DELETE-to-marge plus its LAN peer
notification flow in docs/analysis/FACTORY-RESET-PROTOCOL.md.
Perf: batch GetMigrationSummary's SSH probes into one Run() call via
ssh_probe.go / ssh_probe_apply.go — was ~8 sequential dials at
500-1000 ms each on FW 27 crypto, now one round-trip. Same data shape,
same MigrationSummary fields populated.
Fixes /clockTime and /clockDisplay wire formats — firmware 27 rejects
the legacy flat XML ("Error parsing request"). ClockTimeRequest now
uses utcTime attribute; ClockDisplayRequest emits the nested
<clockConfig> envelope with timezoneInfo/timeFormat/brightnessLevel.
Removes cmd/example-init-speaker (superseded by setup pair).
Co-Authored-By: Claude Opus 4.7 (1M context) <noreply@anthropic.com>